Briggs & Stratton CE8069, 271172, 270962 VoltStarters, Assemble Starter Drive - Roll Pin Retainer

Assemble Starter Drive - Roll Pin Retainer

1.Place clutch (E, Figure 31) on starter shaft and rotate clutch until it drops into place.

7

Figure 32

2.Install pinion gear (D) with beveled edge of teeth up.

3.Place washer (C) and retainer (B) on starter shaft.

4.Press new roll pin (A) through retainer slot and starter shaft hole until pin is centered in shaft.

5.Manually actuate pinion gear on helix to ensure proper movement.

120-Volt Starters

The 120-Volt AC starter motors are not serviceable. If a failure occurs, the entire motor/ switch assembly must be replaced. Refer to the appropriate Illustrated Parts List to obtain replacement part numbers.

114