Briggs & Stratton CE8069, 271172, 270962, 276535, 273521 manual Check and Adjust Crankshaft End Play

Check and Adjust Crankshaft End Play

When crankcase cover or sump is installed with a standard gasket, end play should match values listed in Section 12 - Engine Specifications.

If end play is less than specified, remove cover or sump and install an additional gasket. Do not use more than two gaskets.

If end play is more than specified, remove cover or sump and install a shim per the Illustrated Parts List, or replace the cover or sump. NOTE: If using shims, install as follows:

•Models 120000, 150000 Vertical and Horizontal Engines - install shim on magneto-end of crankshaft (A, Figure 13).

•Models 97700, 99700 Vertical Engines - use additional gaskets to get proper end play (A, Figure 14).

•Models 200000, 210000 Horizontal Engines - install shim on PTO-end of crankshaft (A, Figure 15).

•Models 210000, 280000, 310000, 330000 Vertical Engines - install shim on PTO-end of crankshaft between the timing gear and crankpin (A, Figure 16).

Figure 13

Figure 14

Figure 15

Figure 16

10

139