Briggs & Stratton 276535 Replace Ball Bearing Horizontal Models 200000, Bearing Removal Tools

9

Figure 13

3.Assemble washer (C, Figure 14) to puller screw (D) and insert through large end of removal driver (B). Place open end of support (A) against ball bearing.

4.Insert screw with washer and driver through ball bearing and thread into support. Continue tightening screw until ball bearing is removed.

Figure 14

5.Lubricate outside diameter of new ball bearing. Place ball bearing on support (A, Figure 15).

6.Assemble washer (C) to puller screw (D). Insert large end pilot (B) into oil seal boss in crankcase cover.

7.Insert screw through pilot and thread into support. Tighten screw until ball bearing is seated.

8.Install new oil seal. Use large end of Driver #19320, and press in oil seal until flush with crankcase cover.

9.Install governor idler gear and E-ring.

Figure 15

NOTE: Always install new oil seals when engine is reassembled or when replacing bearings. Always use the correct seal protector to prevent damaging the oil seal during installation.

Replace Ball Bearing

Horizontal Models 200000, 210000

1. Select tools needed from charts below.

Bearing Removal Tools

Tool/Part		Tool/Part #
Description
Washer	690582
Puller Screw	19318
Removal Driver	19401
Removal Support	19440
Bearing Installation Tools
Tool/Part Description		Tool/Part #
Washer		690582
Puller Screw		19318
Installation Driver		19396
Installation Support		19394

2.Remove retaining ring and governor idler gear. Remove oil seal.

3.Assemble washer (C, Figure 16) to puller screw (D) and insert through small end of removal driver (B). Place open side of support (A) against ball bearing with cutout over idler gear shaft.

130