Briggs & Stratton 276535 Vertical Models 97700, 99700, 110000, Installation, Removal, Inspection

Installation

1.Install tank support to tank. Slip fuel hose under governor link and spark plug wire through hole in support as tank is installed. Torque screws to values listed in Section 12 - Engine Specifications.

2.Assemble shut-off valve and fuel filter, if equipped, to fuel hose.

3.Install hose assembly to tank fitting and carburetor fitting with new clamps.

4.Install control panel/trim plate. Torque screws to values listed in Section 12 - Engine Specifications.

5.Add small amount of fuel to tank, open shut off valve, and check for leaks. Repair as necessary.

6.Install air cleaner assembly per Section 1.

NOTE: For snow engines, install the 1 or 2 piece shroud.

7.Start engine and check for leaks. Repair as necessary.

Vertical Models 97700, 99700, 110000, 120000

Removal

1.Drain the fuel tank.

2.Remove air cleaner cover and gas cap.

3.Remove screws and/or pry off the decorative cover (A, Figure 5) installed on the blower housing.

4.Remove screws (B) around the rewind starter and at the bottom of the tank. Release clamp and pull hose off tank fitting, then lift tank off engine.

Figure 5

Inspection

1.Clean gummy or dirty fuel tanks with Briggs & Stratton Carburetor Cleaner #100041 or #100042, or equivalent.

2.Inspect fuel tank for:

•Corrosion

•Leaks

•Broken mounting brackets

3.Check fuel cap and filler neck for:

•Proper seals

•Vents

•Functional quantity gauge (if equipped)

4.Check fuel filter for blockage of any kind.

5.Check fuel shut off valve for proper operation

Clean or replace parts as required. Fuel filter replacement is recommended annually or anytime the fuel system is serviced.

Installation

1.Install fuel hose to tank fitting and secure with hose clamp. Position tank on engine and install screws at bottom of tank and around rewind starter. Torque screws to values in Section 12 - Engine Specifications.

2.Install decorative cover with screws or by snapping tabs into place.

3.Install gas cap and air cleaner cover.

4.Partially fill tank with fuel and check for leaks. Repair as necessary.

Vertical Model 210000

Removal

1.Close shut-off valve, if equipped.

2.Move clamp and disconnect fuel hose and fuel pump fitting. Place hose in appropriate container, open shut-off valve, and allow fuel to completely drain from tank.

3.Move clamp and disconnect fuel hose from tank fitting. Remove shut-off valve and filter, if equipped, from hose and set aside.

4.Remove two bolts with spacers from side of tank, the remove tank from mounting bracket.

4

65