Chapter 2 Preparing to Install Components
Installation
Step 5 Select one of the two installation types:
•Individual
–Installing the Regional Distribution Unit, page 3-2
–Installing Extensions on a Network Registrar Server, page 3-3
–Installing the Key Distribution Center, page 3-7
–Installing the Device Provisioning Engine, page 3-8
•
Step 6 Click Next. Depending on the option you selected in the preceding step, either the Installation Components screen appears, or you begin the lab installation.
Note You must select one of the displayed installation components before you can proceed with the installation.
Installing from the Command Line
To perform the initial installation procedure from the command line:
Step 1 Log into the intended BACC host as root.
Step 2 At the Solaris system prompt, change directory to your
Step 3 Enter this command to start the installation program:
>setup.bin
The installation program verifies that you have installed the required patches to the Solaris operating system. When the verification is complete, the program displays welcome information.
Step 4 Press Enter to continue. The program prompts you to choose the installation type. You can choose to install:
•Individual components
•Lab installation
Step 5 To choose individual components, enter C; or, to choose Lab installation, enter L. For example:
Choose Installation
Choose the type of BPR installation you want to install.
The Lab installation will store all components in the chosen destination.
Otherwise, you can select individual components and destinations.
Enter C for individual components or L for lab [C]:c
Cisco Broadband Access Center for Cable Installation Guide 2.7
| ||
|
