Cisco Systems Broadband Access Center manual Configuring Extensions, Field Name, Description

Chapter 3 Installing Components

Installing Components Using the Graphical User Interface

Field Name	Description
Kerberos Realm Name	Specifies, using a unique name, the Kerberos realm. This must match the
	realm set at the associated components.
IP Address of Primary	Specifies the IP address of the voice technology primary DHCP server.
DHCP Server
IP Address of Primary DNS	Specifies the IP address of the computer which is running the primary
Server	DNS server.
IP Address of Secondary	Specifies the IP address of the voice technology secondary DHCP server.
DHCP Server
IP Address of Secondary	Specifies the IP address of the computer which is running the secondary
DNS Server	DNS server; if that server is being used.

Step 12 Click Next. The Shared Secret Password screen appears.

Step 13 Enter and confirm the shared secret password.

Note Use the shared secret password specified during the RDU installation.

Step 14 Click Next. The Installation Parameters screen appears. This screen identifies the values that you have entered in the previous screens. To modify any of the values entered click Back until the desired screen appears.

Step 15 Click Next. When the installation is complete, the Installed Components Summary screen appears. Click Finish to exit the installation program.

Configuring Extensions

After you install the BACC extensions to Network Registrar, you must configure the extensions. The procedure described in this section makes these assumptions:

•The BACC component is installed in /opt/CSCObpr.

•Network Registrar is installed in /opt/nwreg2.

•The Network Registrar username is admin and the password is changeme. To configure extensions, follow these steps:

Step 1 Log in as root to the Network Registrar server.

Step 2 At the command line, enter these commands:

<NR_HOME>/usrbin/nrcmd -N admin -P changeme -b < <BACC_HOME>/cnr_ep/bin/bpr_cnr_enable_extpts.nrcmd

Step 3 Enter these commands to reload the Network Registrar server:

/etc/init.d/nwreglocal stop

/etc/init.d/nwreglocal start

Alternatively, you can enter this command to reload the DHCP server alone:

Cisco Broadband Access Center for Cable Installation Guide 2.7

OL-19105-01 3-5