Cisco Systems Broadband Access Center manual The program prompts you to confirm the password

Chapter 4 Installing in a Lab Environment

Installing in a Lab Environment Using the CLI

Step 8 Enter the appropriate KDC Interface Address, FQDN, and Realm information and then press Enter. The program redisplays the KDC information and prompts you to confirm this information.

Step 9 Press y and Enter to continue. The program prompts you to enter PacketCable properties. For example:

Enter PacketCable properties

Enter KDC Realm Name
Enter IP Address for			Primary	DHCP []
Enter IP Address for			Primary	DNS []
Enter	IP Address	for	Secondary		DHCP []
Enter	IP Address	for	Secondary		DNS []

Step 10 Enter the appropriate voice technology information. Keep in mind that the KDC Realm name you enter here must be the same as that entered in the previous screen.

Step 11 Press Enter; the program redisplays the PacketCable Properties information and prompts you to confirm the information.

Step 12 Press y and Enter to continue. The program prompts you to enter the shared secret password. This password is a token that a BACC server uses to authenticate communication with other BACC servers. The default password is secret.

Step 13 Enter the password that you want to use for authentication among BACC servers. For example:

Shared Secret Password

Enter the password to be used for authentication among the BPR servers.

If you are performing a lab installation, then the password will be used for all the servers. If this is a component installation, then the password you enter must be the same as the components previously installed.

Enter the Shared Secret Password [secret] secret

The program prompts you to confirm the password.

Step 14 Enter the password again and press y to continue. The program then displays the installation parameters that you selected. For example:

Installation Parameters

This screen shows the installation parameters that you have chosen:

========== Confirmation ==========

The Lab/Demo Installation will install all components using the following parameters:

Installation directory:/opt/CSCObpr

Is this correct (y/n/q/?) [yes]

Step 15 Press y and Enter to install the lab software. The program displays a message when the installation is complete.

Note You use the administrator’s user interface to configure your license keys. Refer to the Cisco Broadband Access Center for Cable Administrator’s Guide for additional information.

Cisco Broadband Access Center for Cable Installation Guide 2.7

OL-19105-01 4-5