Chapter 4 Installing in a Lab Environment
Installing in a Lab Environment Using the CLI
To install BACC in a lab environment, complete the steps described in the “Installing from the Command Line” section on page
Step 1 The program displays this message:
Are you going to use a device(s) that supports Packetcable voice technology?
If you are going to use Packetcable devices we need some more info. Enter Yes to Install Packetcable and No if you don’t want Packetcable installed [No]: Yes
Step 2 Enter Yes and press Enter. A confirmation message appears.
Step 3 Answer the confirmation question appropriately and press Enter. The program displays this message.
Validating LAB settings...
The program then prompts you to enter the destination directory.
Step 4 To accept the default directory, /opt/CSCObpr, press Enter. For example:
Destination Directory
Directory path for BACC_HOME
Location BACC_HOME
Installation Directory [/opt/CSCObpr]
The program then asks you to confirm the directory.
Step 5 Press y and Enter to continue. The program prompts you to enter the Cisco Network Registrar username and password.
Step 6 To enter a Network Registrar username and password:
a.Enter a valid administrator username and password.
b.Enter the password again to confirm it.
For example:
Cisco Network Registrar Username and Password
Enter the administrator username and password for the NR server.
Enter the username and password for the NR server to be used in the lab installation. You must confirm the NR password.
Network Registrar adminstrator Username [admin] admin Network Registrar adminstrator Password [] changeme Confirm Network Registrar Password [] changeme
The program then redisplays the administrator username, password, and password confirmation. It then prompts you to confirm this information.
Step 7 Press y and Enter to continue. The program prompts you to enter the KDC realm name. The realm name must be the same one used with all of the DPEs in the provisioning group. For example:
Enter the Kerberos realm name for the KDC
|
|
| The realm name should be consistent with the realm you give to DPEs in this | |
|
|
| provisioning group. | |
|
|
| KDC Interface Address: | |
|
|
| KDC FQDN: | |
|
|
| KDC Realm: | |
|
|
| Cisco Broadband Access Center for Cable Installation Guide 2.7 | |
|
|
| ||
|
|
|
|
|
|
|
|
| |
|
|
| ||
