Briggs & Stratton CE8069 manual Service Starter Clutch, Vertical Model, Disassemble Starter Clutch

5.Fill fuel tank or open fuel shut-off valve. Connect fuel hose to carburetor and connect spark plug wire.

Service Starter Clutch

Some Vertical model 280000s utilized a sealed starter clutch on the rewind starters. The starter clutch assembly consists of a seal (A, Figure 18), ratchet (B), clutch housing (C), retainer cover (D), and 6 ball bearings (E).

Figure 16

Vertical Model 280000

1.For installation, screws and nuts are available separately from the Illustrated Parts List and are included with complete replacement starters.

2.Attach blower housing with screws (Figure 8) and torque to values listed in Section 12 - Engine Specifications.

3.Attach fuel pump assembly to blower housing, if equipped.

4.Fill fuel tank, open shut-off valve, and connect spark plug wire.

Figure 17

Figure 18

Disassemble Starter Clutch

1.Using Starter Clutch Wrench #19244 and Flywheel Strap Wrench #19433, remove clutch from crankshaft.

2.Remove retaining screws (if used) from clutch housing. Using a screwdriver or wedge, pry the cover from the housing.

NOTE: Perform this procedure over a small bowl to catch the clutch balls as the cover comes off.

Inspect Clutch Parts

1.Using Carb/Choke Cleaner #100041 or #100042, clean the inside of the cover, housing, and clutch balls. Clean the ratchet by wiping with a cloth (do not use spray).

2.Inspect cleaned surfaces for evidence of wear or damage. Replace entire clutch assembly if found.

3.Stand ratchet upright on work surface and add one or two drops of clean oil to the lubrication hole in the Welch plug (B, Figure 18). Allow several minutes for the oil to be absorbed by the felt disc inside the ratchet.

Assemble Starter Clutch

1.Drop one clutch ball into each pocket in the clutch housing.

7

109