Briggs & Stratton 276535, 271172, 270962, CE8069, 273521 manual

	Figure 48
4	- OR -

3.If carburetor is equipped with a plastic choke shaft,

•Install new foam seal and return spring on choke shaft (C, Figure 49) with straight end of spring against choke shaft lever (B).

•Insert choke shaft assembly into carburetor body and engage large end of return spring on anchor pin or boss (A). Lift choke slightly and turn counterclockwise until stop on lever clears anchor pin or boss, then push shaft down.

Figure 49

•Insert choke valve (D) into choke shaft with dimples (E) toward fuel inlet side of carburetor. Actuate the choke shaft to check for proper movement.

4.Install new throttle shaft seal

(C, Figure 50) with sealing lip down in carburetor body until top of seal is flush with top of carburetor (D). Install new foam seal (B) on throttle shaft, then slide shaft into carburetor body. Rotate shaft until flat is facing out. Position throttle valve (E) on flat with numbers facing out, then install screws. Actuate the throttle shaft to check for proper movement.

Figure 50

5.Install idle speed screw and spring, then install idle mixture screw with spring and turn until head of screw touches spring.

6.Using Knockout Pin #19135, press new fuel inlet seat (A, Figure 51) until flush with fuel inlet boss (B).

Figure 51

7.Insert new inlet needle in slot on float, then position float in carburetor body. Secure with new hinge pin and center the pin between the float bosses.

80