Briggs & Stratton 270962, 271172, CE8069, 276535 manual Disassemble Starter Drive - Roll Pin Retainer

Figure 28

4.Place new C-ring over chamfered end of shaft.

5.Align one of the slots (G, Figure 28) of C- Ring Installer #19435 with open end of C- ring (H).

6.Press on tool until C-ring snaps into groove in shaft.

7.Manually actuate pinion gear on helix to ensure proper movement.

Figure 29

Disassemble Starter Drive - Roll Pin Retainer

1.Place starter drive retainer on support block (Figure 29) and drive out roll pin (A, Figure 30) with a 5/32” (.4mm) pin punch. Discard roll pin.

Figure 30

7

Figure 31

2.Remove retainer (B), washer (C), pinion gear (D), and starter clutch (E) from starter shaft.

113