Briggs & Stratton 273521, 271172 Engine Adjustments, Remote Controls, Remote Control Wire Travel

1

ENGINE ADJUSTMENTS

Remote Control Wire Travel

The remote control wire should measure 2.125” (54 mm) when extended outside the casing (Figure 21). After installation, the travel of the remote control wire must be at least 1.375” (35

mm)to properly actuate the choke (on Choke-A- Matic® systems) and the ignition stop switch (if equipped).

Figure 21

Remote Controls

Horizontal Models 110000, 120000, 150000

1.Loosen casing clamp screw (A, Figure 22).

2.Move throttle lever to fast position.

3.Move casing in direction of arrow until slack is removed.

4.Tighten casing clamp screw.

Figure 22

Vertical Models 97700, 99700

1.Loosen casing clamp screw (A, Figure 23) on intake elbow assembly.

Figure 23

2.Move equipment speed control lever (B) to FAST position.

3.Move control wire and casing at governor bracket to align hole (C) in carburetor control lever with hole in carburetor control bracket.

4.Tighten casing screw.

16