Briggs & Stratton 270962, 271172, CE8069, 276535, 273521 manual Snow Hood, Remove, Inspection, Install

Figure 13

Figure 14

Snow Hood

NOTE: Snow engines do not have an air cleaner assembly. Instead, a 1-piece or 2-piece snow hood is installed to protect the carburetor area, retain heat to resist carburetor icing, and provide a mounting surface for engine controls.

Remove

1.Remove choke knob (A, Figure 15 and Figure 16).

2.Remove fasteners and hood (B).

3.Disconnect stop switch wire (C) and primer hose (D).

1

Figure 15

Figure 16

Inspection

1.Check hood for cracks or worn mounting holes. Replace if necessary.

2.Check primer hose for brittleness or leaks and check stop switch and wire for damage. Replace parts as necessary.

Install

1.Connect stop switch wire (C, Figure 15) and primer hose (D).

2.Install hood and fasteners (B).

3.Install choke knob (A) with tab under knob fitting into slot of hood. Actuate the choke knob to check for proper movement.

13