Briggs & Stratton 273521, 271172, 270962, CE8069, 276535 manual Install Carburetor, bracket.4

8.Install emulsion tube using Carburetor Screwdriver #19280 until tube seats (A, Figure 52).

Figure 52

9.Place new bowl gasket on carburetor body and install fuel bowl. Place new washer on solenoid and install.

10.After installing emulsion tube, use compressed air to blow out any chips or debris that may have been loosened while installing tube.

NOTE: On Model Series 280000, 310000, 330000, install main jet after installing emulsion tube.

Install Carburetor

NOTE: Always replace air cleaner gaskets and carburetor mounting gaskets any time the carburetor has been removed for service.

1.Position new gasket on studs with long edge of gasket opposite fuel inlet of carburetor.

2.Hook governor spring (B, Figure 53) in throttle lever hole without grommet. Hook governor link (A) in throttle lever hole with grommet.

Figure 53

3. Hook choke link into outer hole of choke shaft from underneath. Slide other end of choke link into slot in governor control

bracket.4

4.Position carburetor on engine. Install screws or nuts and torque to values listed in Section 12 - Engine Specifications.

5.Connect fuel hose to carburetor and secure with hose clamp.

6.Using new gasket, install air cleaner assembly to carburetor per Section 1. Adjust carburetor, if applicable, per Section 1.

7.After final carburetor adjustment (last step below), use Knockout Pin #19135

(A, Figure 54) to install new limiter cap (B) with flat side facing up.

Figure 54

81