Keiser 1030, 1031 There are four steps to Allenair valve installation, Adjust and mount new valve

Models: 1031 1030

1 14

Page 6

push on board, pull on wire

Pull each of the four wires back out the hole one by one. Save the rubber grommet.

4Test compressor

Note: Keep two things in mind when you are ready to install the new valves.

First, the new valve requires a different mount. Second, the electrical wiring requires the

installation of a single to double adapter on the circuit board.

10-5508 Rev A

Service Department (800) 888-7009

Image 6

Contents

These items have been provided 8 zip ties Solenoid Valve Replacement for 1030/1031 Compressor INTRODUCTIONWORD DEFINITIONS Step One Dismount valve Solenoid Valve Replacement for 1030/1031 Compressorremove both screws Unscrew nut counter-clockwise Step Three Remove electrical wiresStep Two Remove hoses cut tubingremove two screws on lid pop out grommet1030 Circuit Board Diagrams Rev A, B, CRev D - Current Service Department 8002 Install single to double splitter and electrical wires There are four steps to Allenair valve installation1 Adjust and mount new valve 3 Secure and tie wires and replace lid 4 Test compressoropen valve counter-clockwise Step One Adjust and mount new valveposition housing on valve turn nut counter-clockwisepush all the way down on elbow secure valve with zip tiesRight side valve Step Two Install single to double adapter and electrical wiresLeft side valve Left side valveRight side valveStep Two Install single to double adapter and electrical wires push down on board, pull up on connectorFront of compressor pull right side wires to grommet attach wires to boardsingle to double adapter zip tie all wires and hoses Step Three Secure and tie wires and replace lidStep Four Test compressor secure wires to center of CGS boxService Department 800 feel for air flow10-5508 Rev A e-mail info@keiser.com Service Department 8002470 S. Cherry Ave Fresno, CA 1800 Fax 10-5508 Rev A