Next, remove the compression nut that connects the hose to the valve. Replace it with the original compression nut, attach the hose, and tighten the compression nut finger tight. Take the ½ inch wrench and rotate the nut ½ to ¾ turn.
Attach the second hose to the plastic elbow by using the needle nose pliers to push the hose all the way onto the plastic elbow. If you do not properly attach the hose, the pressure from the compressed air will force the hose off the elbow.
push all the way down on elbow
Take two zip ties and mount the valve by using one tie on each side of the valve to hold the valve in place. In order for the ties to stay tight, the smooth side of the tie must face outward.
secure valve with zip ties
Tighten the tie as much as possible, and check to make sure that the valve is securely in place by testing to see if you can move the valve. Once all the slack is removed from the zip ties, remove the excess by cutting it with the wire cutters.
8 | Service Department (800) |
