Manuals / Keiser / Power Tools / Air Compressor

Keiser 1030, 1031 manual remove two screws on lid, pop out grommet

Models: 1031 1030

1 14

Download 14 pages 33.88 Kb

Page 4

Image 4

Next, remove the lid to the computer control system box by unscrewing the screw on either side.

remove two screws on lid

Then remove the rubber grommet by using the needle nose pliers to carefully pop it out of the hole.

pop out grommet

Inside the computer control system box, cut all other zip ties holding the four wires. Trace each of the wires from the valve to the circuit board. There are two per valve, four wires total. The connectors are marked V1 and V2 on the circuit board. Remove each connector from the circuit board by pushing down on the board as you use the needle nose pliers to pull up on the connector. This allows you to safely remove the connectors without flexing or breaking the circuit board.

10-5508 Rev A

Service Department (800) 888-7009

Page 4

Image 4

Keiser 1030, 1031 manual remove two screws on lid, pop out grommet

Contents

Solenoid Valve Replacement for 1030/1031 Compressor INTRODUCTION These items have been provided 8 zip tiesWORD DEFINITIONS Solenoid Valve Replacement for 1030/1031 Compressor Step One Dismount valveremove both screws Step Three Remove electrical wires Step Two Remove hosesUnscrew nut counter-clockwise cut tubingremove two screws on lid pop out grommetRev A, B, C Rev D - Current1030 Circuit Board Diagrams Service Department 800There are four steps to Allenair valve installation 1 Adjust and mount new valve2 Install single to double splitter and electrical wires 3 Secure and tie wires and replace lid 4 Test compressorStep One Adjust and mount new valve position housing on valveopen valve counter-clockwise turn nut counter-clockwisepush all the way down on elbow secure valve with zip tiesStep Two Install single to double adapter and electrical wires Left side valveRight side valve Left side valveRight side valvepush down on board, pull up on connector Step Two Install single to double adapter and electrical wiresFront of compressor attach wires to board pull right side wires to grommetsingle to double adapter Step Three Secure and tie wires and replace lid Step Four Test compressorzip tie all wires and hoses secure wires to center of CGS boxfeel for air flow Service Department10-5508 Rev A Service Department 800 2470 S. Cherry Ave Fresno, CA 1800 Faxe-mail info@keiser.com 10-5508 Rev A