LG Electronics 38WR50MS owner manual Picture ID, RS232C cable

46CUSTOMIZING SETTINGS

ENGLISH

Picture ID

Picture ID is used to change the settings of a specific set using a single IR receiver. The set receiving the IR signal communicates with another set via an RS232C connection. Each set is identified by a Set ID. If you assign the Picture ID using the remote control, only displays with the same Picture ID and Set ID can be controlled remotely.

IR Receiver

RS232C cable

Picture ID

Off

Close

When using the 4 Set (Total Set ID: 4)

Set IDs are assigned as shown in the picture.

1Press the red ON button on the remote control to assign the Picture ID.

2If you press the left/right buttons or press the ON button repeatedly, the Picture ID cycles through OFF and 1 to 4. Assign the ID you want.

Picture ID

Off

Close

yyIf you assign the Set ID to each set with multi-vision, and then assign the Picture ID using the red button on the remote control, the key command is displayed for the set with the same Set ID and Picture ID. A set with different Set IDs and Picture IDs cannot be controlled by IR signals.

yyFor more information on how to assign the Set ID, see "Set ID".

yyThe maximum value of the Picture ID can be set in the Total Set ID menu.

yyPlease refer to the Installation Manual for more information on Total Set ID assignment.

BACK TILE EXIT

ID

ON OFF

NOTE

yyFor example, if the Picture ID is assigned to 2, the upper right display (Set ID: 2) can be controlled by IR signals.

yyFor each set, you can change the settings for the PICTURE, AUDIO, TIME, NETWORK and MY MEDIA menus or the hot keys on the remote control.

yyIf you press the green OFF button for Picture IDs, the Picture IDs for all sets are turned off. If you then press any button on the remote control, all sets will start working again.

yyPicture ID will be disabled while using the MY MEDIA menu.