LG Electronics A-27 Connecting with a Component Cable, Component Input ports, On DVD player

EXTERNAL EQUIPMENT SETUP

EXTERNAL EQUIPMENT SETUP

2

■To avoid damaging any equipment, never plug in any power cord until you have finished connecting all equipment.

■This section on EXTERNAL EQUIPMENT SETUP mainly uses diagrams for the 32/37/42/47/55LE7***

models.

■Image shown may differ from your TV.

CONNECTING WITH A COMPONENT CABLE

This TV can receive Digital RF/Cable signals without an external digital set-top box. However, if you do receive Digital signals from a digital set-top box or other digital external device, refer to the diagram as shown below.

1		Connect the video outputs (Y, PB, PR) of the
		external equipment (digital set-top box, DVD,
		etc.) to the COMPONENT IN VIDEO jacks on
		the TV.			1
2		Connect the audio output of the external equip-
		ment (digital set-top box, DVD, etc.) to the
		COMPONENT IN AUDIO jacks on the TV.			2
3		Turn on the external equipment.
		(Refer to the external equipment's manual for
		operating instructions.)
4		Select the Component1 input source using the			or
		INPUT button on the remote control.
		If connected to COMPONENT IN 2, select
		Component2 input source.
	► HDMI Audio Supported format : Dolby Digital, PCM.				1
	DTS Audio format is not supported.
					2
		Signal	Component	HDMI
		480i/576i	O	X
	480p/576p		O	O
	720p/1080i		O	O
		1080p	O	O
				(24 Hz / 30 Hz /
			(50 Hz / 60 Hz only)
				50 Hz / 60 Hz)

Component Input ports

To achieve better picture quality, connect a DVD player to the component input ports as shown below.

Component ports on the TV	Y	PB	PR
	Y	PB	PR
Video output ports	Y	B-Y	R-Y
on DVD player	Y	Cb	Cr
	Y	Pb	Pr

Downloaded From TV-Manual.com Manuals