| System Setting 21 | |
|
|
|
Initial Setup | 5. Use W/S/A/Dto select the IP mode | |
between [Dynamic] and [Static]. | ||
| Normally, select [Dynamic] to allocate an IP | |
When you turn on the unit for the first time, the | address automatically. | |
initial setup wizard appears on the screen. Set the |
|
|
display language and network settings on the initial |
|
|
setup wizard. |
|
|
1. Press 1(POWER). |
|
|
The initial setup wizard appears on the screen. |
|
|
2. Use W/S/A/Dto select a display language |
|
|
and press ENTER (b). | 6. Select [Next] and press ENTER (b) to apply | |
| ||
| network settings. | |
3.Read and prepare the preparations for the network settings and then press ENTER (b)
while [Start] is highlighted. | Network connection status is displayed on the |
| screen. |
| For details on network settings, refer to |
| “Connecting to your Home Network” on page |
| 16. |
| 7. Check all the settings that you have set in the |
| previous steps. |
If wired network is connected, the network connection setting will automatically be finished.
4.All available networks are displayed on the screen. Use W/Sto select [Wired Network] or desired SSID of wireless network and press
ENTER (b). | Press ENTER (b) while [Finish] is highlighted |
| to finish the initial setup settings. If there is any |
| settings to be changed, use W/S/A/Dto |
| select 1and press ENTER (b). |
3
System Setting
If you have security on your access point, you need to input the security code as necessary.
