T RO U B L E S H O OT I N G
BEFORE CALLING FOR SERVICE
| Problem | Possible Causes | Solutions |
|
|
|
|
|
|
| Dishwasher does not | Door is not completely closed. | Make sure the door is completely closed and latched. |
|
| operate |
|
|
|
| Power supply or power cord is | Connect the power supply or cord properly. |
| |
|
|
| ||
|
| not connected. |
|
|
|
|
|
|
|
|
| Fuse is blown or circuit breaker tripped. | Replace fuse or reset circuit breaker. |
|
|
|
|
|
|
| Dishwasher operates | Unit is connected to cold water. | Check the water supply connection or water heater |
|
| too long |
| setting. (Heating cold water takes longer.) |
|
|
|
|
|
|
| Odor | Previous cycle was stopped before | Operate the Quick Wash cycle with detergent without |
|
|
| completion. | loading any dishes. |
|
|
|
|
|
|
| Water remains in tub | Drain hose is kinked or clogged. | Adjust hose or clear blockage. |
|
| after completion of cycle |
|
|
|
|
|
|
|
|
| Spots and filming on | Low water temperature. | Water supply should be at least 120°F for best wash |
|
| dishes |
| performance. |
|
|
| Wrong amount of detergent used. | Use the recommended amount of detergent. |
|
|
|
|
|
|
|
| Overloading. | Load the proper amount of dishes. |
|
|
| Improper loading. | See the Using Your Dishwasher section. |
|
|
| Insufficient water pressure. | Adjust water pressure to between 20 and 120 psi. |
|
|
| Insufficient detergent. | Add the recommended amount of detergent. See Using |
|
|
|
| Your Dishwasher section. |
|
|
| Rinse aid dispenser empty. | Refill rinse aid dispenser. |
|
|
|
|
|
|
|
| Extremely hard water. |
|
|
|
| The best way to eliminate spots on your dishes is to install a whole house water softener in your home. |
| |
|
| If a water softener is already installed or you do not plan on installing one, |
| |
|
| try adding an “Extra Rinse” option as part of the wash cycle to help minimize this condition. |
| |
|
| To add an Extra Rinse to the cycle, select the wash cycle then press extra rinse. |
| |
|
| Note: When selecting the “Extra Rinse” cycle times and water usage will be increased from normal use. |
| |
|
| To remove hard water build up in tub |
|
|
|
| Remove all dishes, silverware and silverware holder from the dishwasher. Only the racks should remain |
| |
|
| in the tub. |
|
|
|
| Fill a measuring cup with white vinegar approximately 14~17ounces(400~500mL), place the measuring |
| |
|
| cup in the lower rack. |
|
|
|
| Run a “Normal” cycle and select “Extra Rinse” and “Sanitary”, then close the door. |
| |
|
| DO NOT USE ANY DETERGENT |
|
|
|
| Note: Make sure to let the dishwasher complete the entire cycle. The cleaning method should only be |
| |
|
| done as needed. |
|
|
|
|
|
|
|
If you have followed this troubleshooting guide and the problem persists, or if the problem you are experiencing is not listed here,
please call LGE Customer Service at
20