INSTALL THE RANGE 11
Replace the access cover on the back of the range. To replace the wire cover, insert the two tabs into the openings located below the opening and tighten the three screws.
Access cover
ANTI-TIP DEVICE INSTALLATION
WARNING
•Any person should not step or
sit on the oven door. You should install the
- The range could be tipped and injury might result from spilled hot liquid, food, or the range itself.
- If the range is pulled away from the wall for cleaning, service, or any other reason, ensure that the Anti- Tip Device is properly reengaged when the range is pushed back against the wall. Broiling beyond recommended cooking times.
Wall plate | |
bracket |
|
Screw must |
|
enter wood |
|
or concrete |
|
1.Locate the brackets using the template
2.Level the range
Level the range by adjusting the leveling legs with a wrench.
Lower range
Leg leveler
Raise range
Use a level to check your adjustments. Place the level diagonally on the oven rack, and check each direction for level.
First check direction Å . | level |
After check direction Ç . |
|
If the level doesn’t show |
|
level on the rack, adjust |
|
the leveling legs with a |
|
wrench. |
|
FINAL INSTALLATION
•Move range close enough to the opening to plug into the receptacle.
•Slide range into position insuring that both back legs slide under the
•Carefully attempt to tip range forward to insure that the
•Turn on electrical power. Check the range for proper operation as described in owner’s manual.
ENGLISH