COMPONENTS | TEST PROCEDURE | RESULTS |
| Antenna |
|
| Gasket |
|
| Chassis |
|
| Filament |
|
| NOTE: When testing the magnetron, be sure to install the magnetron gasket in | |
| the correct position and be sure that the gasket is in good condition. | |
SENSOR | 1. Disconnect sensor connector from micom | Normal: Approximately |
| ||
| computer board. | |
| ||
| 2. Measure resistance terminal to terminal | |
| ||
| (Select the ohm scale on the meter) | Abnormal: |
|
| |
|
| Infinite or several |
|
| *Sensor cooking condition |
|
| 1. Oven should be plugged in at |
|
| least 5 minutes before sensor |
|
| cooking. |
|
| 2. Room temperature should not |
|
| exceed 95˚F. |
|
| 3. Be sure the exterior of the |
|
| cooking container and the |
|
| interior of the oven are dry. |
|
| 4. The oven will not generate |
|
| microwave energy for the first |
| NOTE: MAKE SURE THE LEAD WIRES ARE | 28 seconds of the sensor |
| IN THE CORRECT POSITION. | cooking cycle. |
| WHEN REMOVING THE LEAD |
|
| WIRES FROM THE PARTS, BE |
|
| SURE TO GRASP THE |
|
| CONNECTOR, NOT THE WIRES. |
|
