LG Electronics LSC27990TT Door removal, Remove lower cover and water feed tube, Installation

Installation

Door removal

Warning

Remove lower cover and water feed tube

Electric Shock Hazard

Disconnect electrical supply to refrigerator before installing. Failure to do so could result in death or serious injury.

If your entrance door is too narrow for the refrigerator to pass through, remove the refrigerator door and pass the refrigerator laterally.

Remove the lower cover by lifting upward, and then pull up the water feed tube while pressing the release ring shown in the figure to the right.

Lower Cover

Water Feed Tube

NOTE

•If a tube end is deformed or abraded, trim the part away.

Disconnecting the tube under the door causes about 1/2 gallon (2 liters) water to flow out. Please put up a big container to prevent it.

Remove the freezer compartment door

1) Remove the hinge cover by loosening the screws. Disconnect all connections except the ground line.

Upper Hinge

2) Remove the keeper by rotating it counter clockwise and then lifting the upper hinge up .

NOTE

Hinge

Cover

Keeper

Connection

Wires

Ground Line

Upper Hinge

•When removing the upper hinge, be careful that the door does not fall forward .

3) Remove the freezer compartment door by lifting it upward. This time, the door should be lifted enough for the water feed tube to be completely pulled out.

Lower hinge

NOTE

•After removing the door, take it into the kitchen where you are installing the refrigerator. Lay it down on a blanket and be careful to avoid damaging the water feed tube.

Remove the refrigerator door

6

1) Loosen the hinge cover screws and remove the cover. Remove connection wire, if any, except for the ground line.

Connection

Wires

2) Remove keeper by rotating it clockwise ( )	Upper Hinge
and then remove the upper hinge by lifting
it up ( ).

3) Remove the refrigerator compartment door by lifting it up.

Keeper

Lower Hinge