INSTALLATION INSTRUCTIONS
7. ADJUST THE SURFACE BURNER LOW FLAME (SIMMER) SETTING
For all surface burners except for the center burner
1.Light all surface burners except for the center burner.
2.Turn the knob on the burner being adjusted to “LO”(LOW).
3.Remove knob.
4.Insert a small, flat bladed screwdriver into the valve stem as shown in Fig.2.
5.Turn the adjustment screw until the flame reaches the desired size.
6.Replace the knob.
Center adjustment screw
Fig. 2
7.Test The Flame Stability.
Test 1 :
Turn the knob from “HI” to “LOW” quickly.
lf the flame goes out, increase the flame size and test again.
Test 2 :
With the burner on a “LOW” setting, open and close the oven or cabinet door quickly.
If the flame is extinguished by the air currents created by the door movement, increase the flame height and test again.
8.Repeat steps 1 - 6 for each surface burner except for center burner.
Only For the center burner
7.Position center burner head, center burner cap, center grate, center knob.
8.Connect power to appliance.
9.Light center burner.
10.Turn the knob on the burner being adjusted to “LO”(LOW).
11.Remove knob.
12.Using a small, flat bladed screwdriver insert into the hole next to the valve stem to adjust outer flame as shown in Fig.3.
13.Turn the adjustment screw until the flame reaches the desired size.
14.Replace the knob.
Adjustment screw next to the valve shaft Fig. 3
15. Test The Flame Stability.
Test 1 :
Turn the knob from “HI” to “LOW” quickly. 
If the flame goes out, increase the frame size and test again.
Test 2 :
With the burner on a “LOW” setting, open and close the oven or cabinet door quickly. 
If the flame is extinguished by the air currents created by the door movement, increase the flame height and test again.
16. | After low flame setting, turn off the burner. |
17. | Disconnected power to appliance. |
18. | Remove knob, grate, burner cap, burner head. |
19. | Remove all screw of the cook top. |
12
1. Disconnect power to appliance.
2. Remove grates, burners caps, burner heads and knobs.
3. Remove the all the screws on the cooktop by philips screwdriver.
4. Remove cooktop by lifting up.
5. Remove LED lamp module of the center valve by unclipping. In this case, the ignition switch should be positioned properly.
6. Replace the cooktop back and secure the screws of the cooktop.
20. | Remove cook top by lifting up. |
21. | Reposition center LED lamp module by |
| hooking. |
22. | Reposition cook top and secure all screws of |
| cook top. |
23. | Reposition burner heads, burner caps, grates |
| and knobs. |
24. | Connect power to appliance. |
