Safety Instructions
-Use the Monitor at the place lower than the altitude of 6562 feet (2000m) to get the best quality of picture and sound.
WARNING
Do not place the Monitor in direct sunlight or near heat sources such as heat registers, stove and so on.
- This may cause a fire.
Do not use the Monitor in damp place such as a bath- room or any place where it is likely to get wet.
- This may cause a fire or could give an electric shock.
Do not use water the Monitor while cleaning.
-This may cause damaged the Monitor or could give an electric shock.
In case of smoke or strange smell from the Monitor, switch it off ,unplug it from the wall outlet and contact your dealer or service center.
- This may cause a fire or could give an electric shock.
Bend antenna cable between inside and outside building to prevent rain from flowing in.
-This may cause water damaged inside the Monitor and could give an electric shock.
Earth wire should be connected.
-If the earth wire is not connected, there is possible a danger of electric shock caused by the current leakage.
-If grounding methods are not possible, a separate circuit break- er should be employed and installed by a qualified electrician.
Power
supplier
Do not attempt to service the Monitor yourself. Contact your dealer or service center.
-This may cause damaged the Monitor or could give an electric shock.
During a lightning thunder, unplug the Monitor from the wall outlet and don’t touch an antenna cable.
-This may cause damaged the Monitor or could give an electric shock.
breaker
-Do not connect ground to telephone wires, lightning rods or gas pipe.
Do not placing anything containing liquid on top of the Monitor.
- This may cause a fire or could give an electric shock.
Do not insert any object into the exhaust vent.
- This may cause a fire or could give an electric shock.
Do not place heavy objects on the Monitor.
- This may cause serious injury to a child or adult.
WARNING in U.K. only
*This set is supplied with a BS 1363 approved 13 amp mains plug, fused at 13 amp. When replacing the fuse always use a 13 amp BS 1362, BSI or ASTA approved type. Never use this plug with the fuse cover omitted. To obtain a replacement fuse cover contact your dealer or “LG Electronics U.K. Ltd.” If the type of plug supplied is not suitable for the mains sockets in your home, then the plug should be removed and a suitable type fitted.
A mains plug removed from the mains lead of this set must be destroyed. A mains plug with bared wires is hazardous if inserted in a mains socket. Do not connect either wire to the earth pin, marked with the letter E or
with the earth symbol 
or coloured green or green and yellow. If any other plug is fitted, use a 13 amp fuse, either in the plug, or at the distribution board.
The wires in this mains lead are coloured in accordance with the following codes: BLUE: NEUTRAL, BROWN: LIVE As the colours of the wires in the mains lead of this set may not correspond with the coloured marking identify- ing the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the ter- minal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.
4
