LG Electronics P154 manual Operating the Dryer, Cycle Setting Buttons

OPERATING THE Dryer CYCLE SETTING BUTTONS

Once you have loaded the dryer:

1Press the ON/OFF button to turn on the

dryer. The lights around the cycle selector knob will illuminate.

2Turn the cycle selector knob to the desired cycle. The display will show

the preset Dry Level, Temperature, Time, and Option settings for that cycle.

SENSOR DRY cycles have preset settings that are selected automatically. MANUAL DRY cycles have default settings, but you may also customize the settings using the cycle setting buttons. Press the button for that option to view and select other settings.

NOTE: To protect your garments, not every dryness level, temperature, or option is available with every cycle. See the Cycle Guide for details.

3If you would like to change the settings for that cycle, press the option button(s)

to display additional settings for that option. Press the button again to cycle through the settings until the desired setting is highlighted.

NOTE: To protect your garments, not every dry level, temperature, or option is available with every cycle.

4	Select any additional cycle
	options, such as ANTI BACTERIAL,
	DAMP DRY BEEP, WRINKLE
	CARE or RACK DRY by pressing
	the button for that option.

5Press the START/PAUSE button to begin the cycle. The display will change,

and the dryer will display the estimated (SENSOR DRY) or set time (MANUAL DRY) remaining

and start tumbling. To pause the cycle at any time, press PAUSE. To resume the cycle where it was stopped, press START/PAUSE again.

DRY LEVEL

Selects the level of dryness for the cycle. Press the DRY LEVEL button repeatedly to scroll through available settings.

•This option is only available with SENSOR DRY cycles.

•The dryer will automatically adjust the cycle time. Selecting VERY DRY or MORE DRY will increase the cycle time, while LESS DRY or DAMP DRY will decrease the cycle time.

•Use a LESS DRY or DAMP DRY setting for items that you wish to iron.

TEMP. CONTROL

Adjusts the temperature setting from ULTRA LOW to HIGH. This allows precise care of your fabrics

and garments. Press the TEMP. CONTROL button repeatedly to scroll through available settings.

NOTE: If the dryer has been stopped for more than 8 minutes, the dryer will turn off automatically.

6When the load is finished, the beeper (if

set) will sound. If you have set the WRINKLE CARE option, the dryer will tumble the load periodically for up to 3 hours.

To prevent wrinkling, remove items from the dryer immediately after the end of the cycle.

7Always clean the lint filter after every cycle.

To clean, pull the lint filter straight up and roll any lint off the filter with your fingers. Do not rinse or wash the filter to remove lint. Push the lint filter firmly back into place.

TIME DRY

Allows you to manually select the drying time, from 20 to 60 minutes,

in 10-minute increments. Use this for small loads or to remove

wrinkles. Use the MORE TIME/LESS TIME buttons to add or reduce the drying time in 1- minute increments.

BEEPER

Adjusts the volume of the end- of-cycle beeper, or turns off the beeper.

29