
CUSTOM PROGRAM
If you have a special combination of settings that you use frequently, you can save these settings as a CUSTOM PROGRAM.
*To Save a Custom Program:
1Turn on the dryer and turn the cycle selector knob to select the desired cycle.
2Use the cycle setting buttons to adjust the settings for that cycle.
3Press the cycle option button(s) for the option you would like to add. A confirmation message will be shown in the display.
4Press and hold the CUSTOM PROGRAM button for 3 seconds.
STEAM FUNCTIONS
To Fill the Steam Feeder
NOTE: You may only save one custom program at a time. Pressing and holding the CUSTOM PROGRAM button will overwrite any previously saved custom program.
To Recall a Custom Program:
1Turn on the dryer.
2Press the CUSTOM PROGRAM button.
3Press the START/PAUSE button to start the cycle.
1 Pull out the drawer. | 3 Fill the steam feeder to MAX with water. |
| Water |
| ONLY |
Drawer | Steam |
| Feeder |
2Lift out the steam feeder.
4Place the steam feeder in the drawer; then push in the drawer until it clicks into place.
IMPORTANT NOTES ABOUT STEAM CYCLES
Before using a Steam Cycle, the steam feeder must be filled with water up to the MAX line. If not, the ADD WATER light will blink. Make sure that the steam feeder is filled with water and the drawer is completely closed. Turn the dryer off then restart the Steam Cycle.
•Only use water. Do not fill the steam feeder with foreign substances, rinse agents, or detergents.
•Before moving the dryer, make sure the steam feeder is empty.
•Do not use distilled water; the water level sensor in the steam generator will not work.
•Be careful to put the Steam Feeder otherwise water will be overflow.
•Wipe up any spilled water around the Steam Feeder and the drawer before starting the dryer.
| wWARNING: |
| • Do not fill the steam feeder with liquids such as gasoline, |
| substances. They give off vapors that could explode. |
2 | • Do not fill the steam feeder with hot water (over 86°F/30°C). |
• Do not drink water from the steam feeder. |