LG Electronics 32LH240H, SAC34026004, 42LH255H, 42LH260H FTG Card Mode of Operation Overview

FTG Card Mode of Operation Overview

Outlined below is the FTG (Free-To-Guest) setup for individual TV control

1.Set up commercial features of TV/STB. Enter Installer Menu and set all desired items as required. (i.e. Tuning Band, Start Channel etc.) Refer to the Installation and Setup Guide of the TV/STB.

2.Load the FTG Configuration Application program onto the PC that will be used to configure the FTG card.

3.Install FTG card into TV/STB’s MPI card slot and connect PC. (See below)

4.Execute the FTG Configuration Application and create a configuration file.

5.Build a Channel Map and ‘Write’ it to FTG card. (Converts card from pass-through to FTG mode.)

6.If necessary, make changes to Installer Menu items using FTG Installer Menu Configuration utility and ‘Write’ them to FTG card.

7.Save the configuration file (*.rml) for future use.

8.Tune TV/STB to a Logical Channel in the Channel Map.

LMT7Z7 Configured Card in FTG Mode of Operation

FTG CARD	TARGET TV/STB
INSTALLER		INSTALLER
MENU		MENU
CHANNEL		CHANNEL
MAP		MAP

Different Model TV/STB Function

Card only copies Installer Menu items

and then installs Channel Map.

FTG CARD	TARGET TV/STB
INSTALLER		INSTALLER
MENU		MENU
CHANNEL		CHANNEL
MAP		MAP

Same Model TV/STB Function

Card installs both Installer Menu items

and Channel Map.

RETAINING SCREW Install after inserting

the LMT7Z7 card.

ANTENNA IN

M.P. I.

RETAINING SCREW Install after inserting

the LMT7Z7 card.

ANTENNA/CABLE INPUT

Receives RF signals.

M.P.I. INTERFACE

Available MPI port.

206-4118 P A G E 9