LG Electronics 37LH260H, SAC34026004 B-LAN Overview, B-LAN Setup and Overview Except 32LH240H

B-LAN Overview

B-LAN Setup and Overview (Except 32LH240H)

Power to the B-LAN module is controlled by Installer Menu Item 118 Power savings. By default, value 003, the B-LAN module is only powered on when the TV is powered on. There are two bits in the Power Savings item to control power to the B-LAN module, one for power during TV Standby mode and one for power during TV Power On mode. When the bit is 0, the B-LAN module is pow- ered. When the bit is 1, the B-LAN module is not powered (Power Savings is Enabled).

	TV Standby State		TV Power On State
Power Saving
	BLAN Power	MPI Slot Power	BLAN Power	MPI Slot Power
1	On	Standby	On	Main
3	Off	Standby	On	Main
7	Off	Standby	Off	Main

The B-LAN module is internal to the TV. It allows the Hotel/Institution headend equipment to communicate with the TV for config- uration and control. This communication is via the institution’r RF distribution system. The control device at the headend (ex FMA- LG101) can control multiple TVs. When the TV is first installed, it must be powered on in order for the headend to be able to com- municate with the B-LAN. At this point, if it is desired for the BLAN to always be powered on, particularly during Standby mode, the BLAN Standby Power Saving mode setting should be downloaded as Disabled. The new settings will not be active until the BLAN actually downloads the configuration data to the PTC and the PTC is reset.

If it known that the application requires only using the MPI card slot and not the embedded BLAN, the installer can go into the Installer Settings menu and enable the BLAN Power Savings mode, in both Standby and TV power on.

206-4118 P A G E 4 5