LG Electronics 42LH255H LT2002 Cloning Connections/Learning Setup, Before you begin cloning

LT2002 Cloning Connections/Learning Setup

Connections for the LT2002 Clone Programmer to Learn the TV Master TV Setup

Antenna

or CATV

Warning: Do not use LT2002 while any PPV card is installed in TV or clone programmer device

THE CLONE HAS CONTROL OF THE TV

THE CLONE IS VERSION		XX
THE TV IS VERSION		XX
THE SW IS REVISION		XX
CLONE CLOCK	= XX:XX
TV CLOCK	= XX:XX

-PRESS ANY KEY TO CONTINUE.

-DISCONNECT CLONE WHEN DONE.

Ferrite Core (TDK, ZCAT

2035-0930)

Connect cable to
TV MPI Jack and		Status
follow on screen
instructions	Indicator

MPI

Reset

Color
• green	battery ok
• red	battery low
Blink pattern
• slow	power on
	no communications
• heartbeat	power on
	communications ok
®

QuickSet II Programmer

LT2002

ZENITH ELECTRONICS CORPORATION, LINCOLNSHIRE, ILLINOIS USA

will be damaged.

Master TV

Clone Programmer

Notes: It is assumed that the TV is connected to a signal source, the source selected is Antenna (RF) In, the signal is from an Analog channel, not a digital channel, all equipment is connected to power and turned on and the LT2002 Clone Programmer main menu (THE CLONE HAS CONTROL OF THE TV) menu is displayed on the TV screen, see above and next page.

GIf an analog channel is not available, tune TV to an Aux source lik AV-1 for cloning purposes.

Before you begin cloning...

•The Master TV should be connected to a good, stable signal from an over-the-air antenna or cable service Analog channel and connected to power. (See above.)

•Teaching and Learning is only possible between identical model devices. (However, the LT2002 Clone programmer can store up to 3 different ‘master’ setups.)

WARNING: Copying a blank or incorrect memory into a TV, STB or other device will cause the TV, STB or other device to operate erratically or become inoperable.

•Use an Installer’s remote to operate Learning and Teaching menus.

•Make sure that the batteries in the Clone programmer are fresh.

•If batteries are removed, the Clone Clock time will be lost.

•Decide if you want to set the time from the Clone program- mer or copy the time to the Clone programmer; from a com- patible TV which has the clock set to the current time.

•Setting the time and transferring it to the Clone or other device is a separate procedure.

•Follow the connection diagram above to connect the Clone to a Master TV TV display panel. After learning is complete, to another identical TV TV display panel to “teach” it the master setup.

•See the Clone Troubleshooting section to resolve problems.

Turn to the next page to continue Cloning Setup.

P A G E 2 2 206-4118