Part 4 ACCESSORIES INSTALLATION
Pedestal Installation Instructions |
The pedestal accessory includes:
• Drawer divider (1) | • | Wrench (1) |
• Screws (18) † | • | Retainers (4) †† |
3 Place the dryer on the pedestal. Make sure the front and back feet are in the correct positions. The dryer feet will fit into the innermost positions as shown.
For dryer
For washer/combo
† Dryer installation only uses 8 screws †† For dryer only
Tools Needed for Installation:
•
• Wrench (supplied)
To ensure safe and secure installation, please thoroughly follow the instructions below.
1 To set the dryer to the same height as the washer, fully retract the leveling feet of the dryer by turning them counterclockwise, then turn them clockwise
NOTE: The appliance and pedestal assembly must be placed on a solid, sturdy, level floor for proper operation.
Retract fully | Then loosen |
|
2 Insert the
Retainer
4 Make sure the screws on the pedestal align with the holes in the retainers, then install 4 screws at each corner to securely attach the appliance to the pedestal.
NOTE: If the screws are not installed properly, noise and vibration may result.
Move the appliance to the desired location.
5 | Loosen the locknuts on all 4 leveling feet of the |
pedestal until you can turn them with the wrench. | |
Turn clockwise to raise or counterclockwise to lower |
until the pedestal is level and all 4 feet are solidly against the floor.
Raise | Lower |
6 Securely tighten all locknuts by hand.
NOTE: Noise and vibration may result if locknuts are not tightened.
Be sure to connect the appliances to all water, power, or gas lines and draining or venting connections before operation.
If there is excessive vibration during the first operation after installation, slightly adjust the leveling feet.
Locknut
1 7
