The "SETGCM" Command
The "SETGCM" command initializes the
•The
•A new module is added to the network.
•The workstation phone number is changed on the SiteScan connections page.
•The three letter system name is changed.
To issue this command, connect to the system through SiteScan, press [ESC], type SETGCM, and press [ENTER].
NOTE: If the "Use This Number?" parameter on the LGM module driver parameter page is set to "YES", the
Transferring Memory
NOTE: You must use FB Link v2.7 or later in order to transfer to any module containing Exec 6.0 or later.
If you have any problems during this procedure, contact Technical Support at
1.Log into SiteScan, using a workstation or portable computer that is direct connected, modem connected, or connected directly on the Liebert network.
2.Go to the
•Press the [ESC] key
•Type: MO ,, 1, 15
If the module is
3.Look at the Modstat page and verify that the module's type is
4.Download memory for “This Module.”
5.When the memory transfer is finished, go to the module's Modstat page (see Step 2). Check the screen display's FB List to verify that the module driver you intended to transfer is in the module.
Rev. | 9 | © |