Installation
2.2.1 Unloading the UPS
! CAUTION
This UPS is very heavy (see weight in Table 1). At least two people should assist in unloading it from the pallet.
1.Use a ratchet or wrench, 1/2" (13mm), to remove the four mounting bolts from the front and rear pallet brackets. Remove the mounting brackets from the pallet and UPS. Keep the brackets for future transportation of the UPS or for additional stability of the UPS once in place.
2.Remove the metal ramp from the bottom of the UPS.
Pull ramp out from under front of unit, then turn ramp over
3.Fit the ramp flange in the slot in the rear of the pallet (back of unit) as shown below.
Fit ramp in
rear of pallet
4.Using two people, slowly move the UPS down the ramp until the UPS is on a level surface.
9