General product information

3.3.2Unit Handling

If possible, transport the unit using a forklift or pallet jack.

If using a forklift or pallet jack, ensure that the fork tine length is suitable to safely move the packaged unit.

Liebert recommends keeping the unit in the protective packaging until it has been moved to the installation site.

When handling and unpacking the unit, exercise great care to prevent damage.

Do not lift the unit any higher than 6" (152mm) while moving it. If it must be lifted higher than 6" (152mm), exercise great care and keep all personnel who are not helping move the unit at least 20' (5m) away from the unit.

The Liebert XDH ships with four outrigger-style wheels to permit rolling it into position. Liebert recommends using a forklift or pallet jack to move the Liebert XDH as near as practical to its installation site before removing it from the shipping pallet.

3.3.3Unpacking the Unit

1.Remove the exterior stretch-wrap packaging from around the unit, exposing the protective corner and side packaging planks.

2.Remove the ramp, corner and side packaging planks from the unit, exposing the bag over the unit. Remove the bag when ready to install the Liebert XDH.

Figure 5 Removing shipping package

Exterior stretch wrapping surrounds other protec- tive shipping features

Ramp

(secured to the Liebert XDH by a layer of shrink-wrap)

NOTE:

One ramp will be shipped per order.

Planks at the corners and on the sides protect the Liebert XDH during shipping

Leave the plastic bag on the unit until it is off the pallet and ready to be installed

Ramp

(removed from pallet)

6

Page 10
Image 10
Liebert XDH manual Unit Handling, Unpacking the Unit