Liebherr 211111 7085270 - 00 General safety information, Installing the appliance, Contents

Models: 211111 7085270 - 00

1 8
Download 8 pages 3.9 Kb
Page 2
Image 2
General safety information

General safety information

Contents

 

1

General safety information

2

2

Putting into operation

2

2.1

Installing the appliance

2

2.2

Changing over door hinges

3

2.3

Built-in

4

2.4

Connecting the appliance

8

The manufacturer works constantly on the further development of all the types and models. Therefore please understand that we have to reserve the right to make design, equipment and technical modifications.

To get to know all the benefits of your new appliance, please read the information contained in these instructions carefully. The instructions apply to several models. Differences may occur. Text relating only to specific appliances is marked with an asterisk (*).

Instructions for action are marked with a Contents, the results of action are marked with a Putting into operation.

1 General safety information

 

DANGER

identifies a situation involving direct

 

 

danger which, if not obviated, may

 

 

result in death or severe bodily

 

 

injury.

 

WARNING

identifies a dangerous situation

 

 

which, if not obviated, may result in

 

 

death or severe bodily injury.

 

CAUTION

identifies a dangerous situation

 

 

which, if not obviated, may result in

 

 

minor or medium bodily injury.

 

NOTICE

identifies a dangerous situation

 

 

which, if not obviated, may result in

 

 

damage to property.

 

 

 

 

Note

identifies useful information and tips.

It is important that the procedures and directions given in these instructions are complied with in order that the appliance is correctly installed and works properly. Read and grasp all the information in these instructions before the appliance is installed.

2 Putting into operation

2.1 Installing the appliance

1 General safety information WARNING

Risk of fire due to short circuit!

If the mains cable/connector of the appliance or of another appliance touch the rear of the appliance, the mains cable/ connector may be damaged by the appliance vibrations, leading to a short circuit.

u Stand the appliance so that it is not touched by connectors or main cables.

u Do not plug the appliance or any others into sockets located near the rear of the appliance.

2 Putting into operation WARNING

Fire hazard due to dampness!

If live parts or the mains lead become damp this may cause short circuits.

u The appliance is designed for use in enclosed areas. Do not operate the appliance outdoors or in areas where it is exposed to splash water or damp conditions.

u Only use the appliance when it is installed.

2.1 Installing the appliance WARNING

Fire hazard due to refrigerant!

The refrigerant R 600a is environmentally friendly but flam- mable. Escaping refrigerant may ignite.

u Do not damage the piping of the refrigeration circuit.

Manual background WARNING

Fire hazard and danger of damage!

u Do not place appliances emitting heat e.g. microwaves, toasters etc. on the appliance!

Manual background WARNING

Blocked ventilation openings pose a risk of fire and damage! u Always keep the ventilation openings clear. Always ensure

that the appliance is properly ventilated!

q In the event that the appliance is damaged, contact the supplier immediately before connecting to the mains.

q The floor at the site must be flat and level.

q Do not install the appliance in a location where it is exposed to direct radiation of the sun, next to a cooker, heater and similar.

q The appliance is suitable for integrated, under-worktop use. q Ventilation is effected by way of the plinth.

q Do not install the appliance without assistance.

q Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m2 per 8 g of R 600a refrigerant used in the appliance. If the room in which the appliance is installed is too small, a flammable gas-air mixture may form in the event of a leakage in the refrigera- tion circuit. The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance.

u Detach the connecting cable from the rear of the appliance, removing the cable holder at the same time because other- wise there will be vibratory noise!

After installation:

u Remove the protective film from the decorative trims.* u Remove all transit supports.

u Unscrew the red transport lock. Close the vacated retaining hole using the stopper (60).

u Dispose of packaging material.

For Side-by-Side installation, freezer and refrigerator side by side:

u Always install the freezer on the right of the refrigerator, as seen from the front.

w No condensate forms between the appliances thanks to the side wall heating system foamed in on the left.

Note

u Clean the appliance .

2

Page 2
Image 2
Liebherr 211111 7085270 - 00 General safety information, Installing the appliance, Putting into operation, Contents