Putting into operation
Built-under variants:
Fig. 9 for recess height 820 or 870 mm A = Height of recess
B = Height of unit plinth
C = Height of unit door
D = Base height of
Recess | Height of unit | Height of unit | Base height of |
height A | plinth B | door C | unit plinth D |
820 mm | 100 mm | 716 mm | 100 mm |
820 mm | 170 mm | 646 mm | 100 mm |
870 mm | 150 mm | 716 mm | 150 mm |
870 mm | 220 mm | 646 mm | 150 mm |
Note
u Before assembling the door of the unit, make sure that the admissable weight of the unit door is not exceeded.
u Otherwise damage to the hinges and resultant malfunction cannot be ruled out.
Model | Max. weight of unit |
| door |
UIK | 10 kg |
UIG | 20 kg |
2.3.1 Installing the appliance
uDetach the connecting cable from the rear of the appli- ance, removing the cable holder at the same time because otherwise there will be vibratory noise!
uLay the connecting cable with the help of a string in such a way that the appliance can be easily connected after fitting.
Fig. 8 | Fig. 10 | |
u Extend the front | ||
| depending on recess height. | |
| Slide in and align the appliance: | |
| NOTICE |
|
| Risk of harm to flooring susceptible to damage! | |
| u Place a strip of cardboard under the | |
| approx. 10 cm x 60 cm, one at either side. Cut the strips out | |
| of the packaging. For opening heights less than 826 mm, | |
| use strips of a firm but thin material. | |
| u After the appliance has been slid in, remove the strips. |
|
| u Slide the appliance into the | |
| recess and align the front | |
| edges of the hinges so that | |
| they are flush with the side | |
| wall of the unit. | |
| Fig. 11 | |
| w The distance between the front edge of the side wall of the | |
| unit to the appliance body is 41.5 mm all the way round. | |
| (Allow for door stop components, such as knobs and sealing | |
| lips.) | |
| For units with door stop components (knobs, sealing | |
| lips etc.): | |
| u Allow for the extra distance (depth of the door stop compo- | |
| nents): Allow the hinges to protrude by the additional | |
| distance required. |
5