Liebherr 7082 218-03 manual Insertion into row of kitchen units, Notes on assembling decor panels

Insertion into row of kitchen units

Fig. U. 600 mm appliances can be installed in a row of kitchen units. To adapt the height of the appliance to the surrounding furniture a top unit 1 can be added.

A gap of at least 50 mm depth must be provided behind and along the entire width of this unit so as to ensure sufficient ventilation. The area of ventilation underneath the ceiling should be at least 300 cm2. The greater the area the more economically the appliance will run.

WWhen installing with standard kitchen units (max. depth 580 mm) and decor panels of max. 2 mm thickness, the appliance can be set up right next to the kitchen unit.

The door protrudes 34 mm from the side of the kitchen unit and 51 mm at the front. This enables it to be opened and closed without difficulty.

WWhen setting up the appliance next to a wall 4, a mini- mum distance of 36 mm must be provided on the hinge side between the appliance and the wall (for the handle when the door is open).

1 top unit	3 kitchen unit side panel
2 refrigerator/freezer	4 wall

Notes on assembling decor panels*

600 mm wide and 1841 mm high appliances can be matched or contrasted with your existing kitchen colour scheme by attaching a decor panel and frames.

The panels are available from your kitchen furniture supplier. The frames can be fitted later and are available from your dealer.

If you wish to fit the decor panel yourself, you require a drill or cordless screwdriver to pre-drill the retaining holes. The door handles are to be replaced by the rigid handles includ- ed in the decor frame retrofit set.

For further instructions and dimensions see the installation instructions included in the retrofit kit.

[mm]	B	D C
		E	F
A							GB
S		56,5			10
I			II			9 Torx	25
	8			8		25	20
7		8
						7
8	SW5
						SW5
	10	21					9
		20	25		180°	25	20
*
13		5	9			21
2
			14
		4					18 *
15		3	17*	16*
			Torx	15
1
13
15		31*					30
T1						32
T

All types and models are subject to continuous improvement and the manufacturer therefore reserves the right to make modifications in the shape, equipment and technology.

1

2

3

U4

min.

300 cm2 50 . min

631 614

580

ca. 36

[mm]

K/SK/es..0 17