You will also need the following tool for the installation: cordless Torx screwdriver ®15, 20, 25, hexagon spanner 13.
Replacing the door stop
If necessary you can change the door stop, please see further instructions from “installation information” onwards
WTo make it easy to fit, push the appliance
WDismantle the closing damper :
Caution when dismantled the closing damper retracts! W Unscrew the holder 1
W Unscrew the ball pins 3, together with the closing damper 2, from the door, and place to one side.
Caution: Do not pull the closing damper from the ball pins. It could become damaged
W Pull the cover components 5, 6, 7 and 8 forwards and upwards with the aid of a slotted screwdriver.
W Simply loosen the fastening screws 9 on the body of the appliance at the top and bottom .
- Push the doors outwards and take them off their hinges.
WSet the fastening screws 9 on the opposite side, and screw in briefly.
WScrew out the door fastening screws bl and place the hinges diagonally.
Caution Do not allow the hinges to fold inwards - an injury could be caused!
-Use a cordless screwdriver - to fasten the screws. The screws bl are
WUse the plugs to seal bm the former fastening holes.
WFit the doors of the appliance onto the prefitted screws 9 and fasten the screws.
Refit the closing damper 2* :
WScrew 1 the holder back on
WScrew the ball pins 3together with the closing damper 2 into the new fastener holes.
WRefit all the cover components .
9 6
5
9 7
8
9
7
11
10 |
10
22
