Liebherr 7082 532-00 To start the ice maker, To make ice cubes, Cleaning the ice-cubetray

To start the ice maker

The ice maker will only work if the combined refrigerator-freezer is connected to the electricity supply. It will only make ice cubes if the freezer compartment is operating.

The ice maker is in the top left drawer in the freezer compartment of the combined refrigerator-freezer. You can identify this drawer by its labelling ”Ice maker”.

To switch on

•Pull out the drawer.

•Press the ”ON/OFF” button so that the control lamp comes on.

• Close the drawer.

Note: The ice maker can only make ice cubes if the drawer is completely closed.

To switch off

If you do not need any ice cubes the ice maker can be switched off independently of the freezer compartment.

•Press the ”ON/OFF” button for approx. 1 second so that the control lamp goes out.

Note: If the ice maker is switched off, the empty drawer can also be used to freeze and store food.

To make ice cubes

After you start the ice maker for the first time it may take up to 24 hours before the first ice cubes are ready.

Please note that the first three batches of ice must not be consumed or used.

The production capacity depends on the temperature inside the freezer compartment. The lower the temperature, the more ice can be produced over a period of time.

The ice cubes fall out of the ice maker into the drawer. When the ice reaches a certain level in the drawer, the appliance stops producing ice automatically.

If you require a large quantity of ice you can swap the drawer to the right with the complete ”Ice maker” drawer. When you close the drawer the ice maker will immediately start production.

GB

Cleaning the ice-cube tray

The ice-cube tray can be cleaned. Use the following method.

•The IceMaker must be switched on.

•Remove any ice cubes from the drawer.

•Hold the ”ON/OFF” button for 10 seconds (after 1 second the IceMaker will switch off - the LED will go out).

•After you have held the ”ON/OFF” button for 10 seconds the

LED will start to flash for 60 seconds.

• Insert the drawer during

these 60 seconds. Then the ice-cube tray will move

into an angled position.

• Remove the drawer - the ice-cube tray can now be cleaned. The best way of doing

this is with warm water and a little washing-up liquid.

•Press the ”ON/OFF” button and close the drawer. The IceMaker will then immediately restart with its production of ice cubes.

This procedure should also be completed if you switch off the IceMaker. This ensures that no water or ice will be left in the ice- cube tray.

Malfunction

If a malfunction occurs during operation, check whether it is due to an operating error.

You may be able to rectify the following faults yourself:

•The ice maker cannot be switched on

-Is the combined refrigerator-freezer connected to the mains electricity supply?

•The ice maker is not making any ice - Is the ice maker switched on?

- Is the water supply line open?

- Is the ”Ice maker” drawer closed properly?

If you are unable to rectify the fault yourself or if the control lamp above the ”ON/OFF” button flashes, contact our customer service department. Refer to the section headed ”Troubleshooting” in the operating instructions for the combined refrigerator-freezer for details of the type plate data you will be required to quote.

5