Liebherr 7082 532-00 Fitting the kitchen unit door, Niche should be 562 mm, Wide

	If the unit walls are 19 mm thick=			W Fit the fastener		=		=
	the niche should be 562 mm				traverse dm to the
-	wide:			-	unit door:
	Push the appliance into the niche				To do this screw off
	until the front edges of the hinges are				the traverse above
	flush with the side walls of the unit, on			-	the lock nuts dn .
	unitswith door stopper components				Use the assembly
	(burls, sealing lips etc.) please pay attention to the dimensions				devices dl to sus-
	of these! Allow the hinges to protrude by the amount of their				pend the traverse
	dimension.Push the appliance against				onto the inside of
	the unit wall, hinge-side facing.	27	28		the unit door align it			31
W Use the adjusting feet cq to align the					to the centre (draw		30
					a short centre line
	appliance, using the wrench supplied				onto the unit door, bring the tip of the arrowon to it, the dis-
	cr so that it is positioned upright.	25			tances to the outer edge must be the same to the right and to
	Make sure the body of the appliance				the left).
	is parallel with the front edges of the				Fasten the fastening traverse dm in the centre:
	sides of the unit.	26		W
W Screw the plastic bracket csusing M5				-	use at least 6 screws for chipboard doors,
	screws ct on the handle side of the			-	use 4 screws at the edges on cassette doors.
-	appliance.			-	Pull the assembly devices dl upwards and push them, at an
	Align the bottom of the plastic bracket cs flush with the front				angle, into the receiving apertures.
	edge of the floor of the unit.
	If there are door stopper elements (burls, sealing lips etc.)					32
	take account of the dimensions of these and align them to be							31
	parallel with the front edge
	of the hinge.						Z	X
W Screw the appliance into
	the niche .							Y
- Uselongchipboardscrews
	to screw through the cu	29
	hinge lugs at the top and
	the bottom.		29
- Use a long screw cu to prefit the central					Hinge the unit door onto the appliance door/adjusting pins do,
				W
	slotted hole on the plastic bracket cs.Fold
					loosely screw on the lock nuts dnonto the adjusting bolts.Close
	back the cover on the plastic bracket, and
			27		the door.
	close the door of the appliance.
				W Check the distance of the door against the surrounding unit
				-	doors.
Fitting the kitchen unit door					Align the unit door to be flush with the surrounding unit doors:
					Even the sides X by pushing, and the height Y and lateral
Note:You need the assembly devices dl for both doors.You					inclination, using the adjusting bolts do - with a screw driver.
				-	Tighten the lock nuts dn .
therefore need to fit the unit doors one after another.
				W Screw the ap-
	30
					pliance door dp
					onto the unit door
					with the fixing
			31	-	bracket em:		41
	32				Makesurethetwo
					metal edges are
					flush, symbol //.
	31				Then predrill the
					fastening holes (if
					necessary use a
					braddle to punch
	33				holes)and screw
					firmly.

W Check the presetting of 8 mm (distance between appliance door and lower edge of traverse).

WPush the assembly devices dl to the height of the unit door, lower edge of the stop ▲ on the assembly device = upper edge of the door to be fitted.

24