Life Fitness 95C owner manual Setup, Electrical Power Requirements

1.2Setup

Read the Operation Manual before setting up the Upright Lifecycle® Exercise Bike.

Electrical Power Requirements

An optional external power supply is available for the Inclusive Upright Lifecycle Exercise Bike. The external power supply requires an AC power supply according to the electrical configurations listed in the chart below.

Supply Voltage	Frequency	Rated Current
(VAC)	(Hz)	(Amps)
100	50 / 60	1.6
110	50 / 60	1.6
120	50 / 60	1.6
200	50 / 60	.8
220	50 / 60	.8
230	50 / 60	.8
240	50 / 60	.8

NOTE: Do not modify the plug provided with this product. If the plug does not fit into an available electrical outlet, have a proper outlet installed by a qualified electrician.

Where to place the Inclusive Upright Lifecycle Exercise Bike

Following all safety instructions in Section 1.1, move the bike to the location in which it will be used. See Section 3, titled Specifications, for the dimensions of the product footprint (assembled dimensions). Allow a distance of 21 to 30 centimeters

(8 to 12 inches) between the bike and other objects or surfaces on either side. Allow a distance of 1 meter ( 3 feet ) from the front or rear of the bike to any other object or surface.

How to stabilize the Inclusive Upright Lifecycle Exercise Bike

After placing the bike in position, check the unit’s stability by attempting to rock it from
side to side. Any slight rocking indicates that the unit must be leveled. Determine which
foot is not resting completely on the floor. Loosen the jam nut (A) with an open-end M17
wrench, and rotate the stabilizing foot (B) to lower it. Verify that the bike is stable, and
repeat the adjustment as necessary until the unit no longer rocks. Lock the adjustment by
tightening the jam nut against the stabilizer bar.	A
The STEP-UP PLATFORM is shipped in a configuration to be placed on the user left side
of the Inclusive Upright Lifecycle® Exercise Bike (as shown). The STEP-UP PLATFORM is	B
designed for use on either side of the Inclusive Upright Lifecycle® Exercise Bike.

If the STEP-UP PLATFORM is to be used on the user right side of the Inclusive Upright Lifecycle® Exercise Bike:

1.Remove the four SCREWS (AA) securing the STEP-UP PLATFORM (BB) to the STEP LOCATOR BRACKET (CC).

2.Flip the STEP LOCATOR BRACKET (CC), align the STEP LOCATOR BRACKET to the STEP-UP PLATFORM (BB) and secure using the four previously removed SCREWS (AA). Tighten the SCREWS securely. Do not overtighten the SCREWS.

Peel the protective liner from each of the six NON-SLIP PADS (DD) and place them on the underside of the STEP LOCATOR BRACKET (CC) as shown.

Carefully lift the rear of the Inclusive Upright Lifecycle Exercise Bike and position the STEP-UP PLATFORM under the REAR STABILIZER (EE) as shown. Be sure the REAR STABILIZER sits completely on the floor within the STEP LOCATOR BRACKET (CC).

6