Life Fitness FT4 user manual Assembling the Treadmill

ASSEMBLING THE TREADMILL

Tools Required: Metric Wrench Set, Metric Allen Wrench Set, Phillips Screwdriver

1.Locate the USER LEFT UPRIGHT (A) (upright with pre-fed CONSOLE CABLE). With the HANDLEBAR EXTENSION facing the rear of the unit, position the USER LEFT UPRIGHT near the USER LEFT UPRIGHT BRACKET (B). Connect the CONNEC- TORS (C) leading from the USER LEFT UPRIGHT and USER LEFT UPRIGHT BRACKET. Slide the USER LEFT UPRIGHT over the USER LEFT UPRIGHT BRACKET until fully seated. Install one 5/8" BUTTON HEAD SCREW (1) and LOCK WASHER (2) each in the side and rear mounting holes of the USER LEFT UPRIGHT. Finger-tighten the SCREWS.

Caution: Do not pinch the cable when sliding the USER LEFT UPRIGHT (A) over the USER LEFT UPRIGHT BRACKET (B).

2.Locate the USER LEFT UPRIGHT BRACE (D). Using four 5/8" BUTTON HEAD SCREWS (1) and LOCK WASHERS (2), secure the USER LEFT UPRIGHT BRACE to the front of the USER LEFT UPRIGHT (A) and the FRAME (E). Finger-tighten the SCREWS.

3.Locate the USER RIGHT UPRIGHT (F). With the HANDLEBAR EXTENSION facing the rear of the unit, position the USER RIGHT UPRIGHT near the USER RIGHT UPRIGHT BRACKET (G). Slide the USER RIGHT UPRIGHT over the USER RIGHT UPRIGHT BRACKET until fully seated. Install one 5/8" BUTTON HEAD SCREW (1) and LOCK WASHER (2) each in the side and rear mounting holes of the USER RIGHT UPRIGHT. Finger-tighten the SCREWS.

4.Locate the USER RIGHT UPRIGHT BRACE (H). Using four 5/8" BUTTON HEAD SCREWS (1) and LOCK WASHERS (2), secure the USER RIGHT UPRIGHT BRACE to the front of the USER RIGHT UPRIGHT (F) and the FRAME (E). Finger-tighten the SCREWS.

5.Locate the HANDRAIL (J). With the stepped exten- sion end of the HANDRAIL facing right, position the HANDRAIL between the LEFT and RIGHT UPRIGHTS (A) & (F) at the HANDRAIL MOUNTING HOLES. Secure the user left side of the HANDRAIL to the LEFT UPRIGHT using the 2" BUTTON HEAD SCREW (3) and one LOCK WASHER (2). Secure the user right side of the HANDRAIL to the RIGHT UPRIGHT using one 5/8" BUTTON HEAD SCREW

(1) and one LOCK WASHER (2).

6.Locate the DISPLAY CONSOLE (K). Position the DISPLAY CONSOLE near the top ends of the LEFT and RIGHT UPRIGHTS (A) & (F). Connect the CONNECTOR (L) leading from the top of the USER LEFT UPRIGHT to the CONNECTOR (L) leading from the user left side of the DISPLAY CONSOLE. Slide the DISPLAY CONSOLE onto the TOP UPRIGHT EXTENSIONS. Secure the DISPLAY CONSOLE to the uprights using two 5/8" BUTTON HEAD SCREWS (1) and LOCK WASHERS (2) on either side of the DISPLAY CONSOLE. Tighten the SCREWS securely.

Caution: Do not pinch the cable when sliding the DISPLAY CONSOLE (K) onto the LEFT and RIGHT UPRIGHTS (A) & (F).

7.Tighten all SCREWS securely.

8.Position the TREADMILL into the desired location for use.

9.Plug the TREADMILL into a proper electrical outlet as instructed in SECTION 1.2 of this manual.

5