4.3WORKOUT DESCRIPTIONS
QUICK START
QUICK START is the fastest way to begin exercising and bypasses the steps of selecting a specific workout program. The intensity level for the workout is set automatically and remains the same unless manually changed. To change the level, use the LEVEL ARROW keys or use the NUMERIC KEYPAD to enter a higher or lower level number. After the workout has been in progress for 12 seconds, the MESSAGE CENTER displays “ENTER WEIGHT”, which the computer requires to calculate total calories. Using the ARROW KEYS, increase or decrease the displayed weight to the correct value (or enter the weight using the NUMERIC keypad).
MANUAL WORKOUT
The MANUAL program sets an intensity level that does not change automatically. While the workout is in progress, increase or lower the intensity level as desired using the ARROW keys.
RANDOM WORKOUT
The RANDOM program creates a terrain of hills and valleys that varies with each workout. More than one million differ- ent patterns are possible. Because workout levels are greater in this workout than in the HILL workout, it is recommend- ed that the RANDOM workout be set one or two levels lower than the workout level which would normally be selected in the HILL workout.
FAT BURN
The FAT BURN workout is designed to maintain a user’s heart rate at 65 percent of the theoretical maximum† for optimal results. Throughout the workout, the user wears a chest strap or grips the Lifepulse system sensors. If the user is not wearing a chest strap, the WORKOUT PROFILE window displays a heart shape and the MESSAGE CENTER displays a prompt to grip the sensors. The console continuously monitors and displays the heart rate, adjusting the intensity level of the Life Fitness
CARDIO
The CARDIO workout is virtually identical to FAT BURN, except the target heart rate is calculated at 80 percent of the theoretical maximum. As with FAT BURN, the user wears a chest strap or grips the Lifepulse system sensors throughout the CARDIO workout.The higher target promotes cardiovascular improvement by placing a heavier workload on the heart muscle.
HILL
The Life
Each HILL workout goes through four phases, each marked by different intensity levels. The WORKOUT PROFILE window dis- plays the progress of these phases, as seen in the chart following these descriptions below. As noted in the descriptions, the heart rate should be measured at two stages in the workout to gauge its effectiveness. To do so, wear the chest strap or continuously grip the Lifepulse system sensors. Note that the MESSAGE CENTER does not display a request for a heart rate measurement during a HILL workout.
1
2Plateau increases the intensity slightly, and keeps it steady, to bring the heart rate to the low end of the target zone. Check the heart rate at the end of this phase.
3Interval Training is a series of increasingly steeper hills, alternating with valleys (or periods of recovery). The heart rate should rise to the high end of the target zone. Check the heart rate at the end of this phase.
4
18