SM30 Unpacking & Assembly Instructions
8
F. With the top plate on the guide rods, bolt on the top plate to the top of the cells as
shown in Figure 8 using a 9/16” socket and combination wrench and the 3” bolts
(with cap washers) that were previously inserted.
Figure 8. Bolt on the top plate.
5. Bolt the floating pulley into the 190 lb weight stack using a 7/8” combination wrench
(NOT for the tricep pushdown weight stack- the one with the tricep back rest mounted to
the frame as shown in Figure 7). You will need to remove the pulley from the housing to
thread the plug into the weight stack bayonet. Make sure the 9/16” jam nut is threaded 1-
5/8” away from the pulley as shown in Figure 9. Leave the pulleys out since you will need
to have them out when the cable is routed.
Figure 9. Bolt the floating pulleys into the 190 lb weight stacks.