SM51 Unpacking & Assembly Instructions
12
INSTALLING THE CABLES
The SM51 uses five cables. There are three different types of cable used on the SM51. They
are:
1. Adjustable crossover cables (ball end cables) (2).
2. Low row cable (the long cables) (1).
3. Lat pulldown and tricep cables (2).
The lat and tricep cables can be identified by their short length, the low row cable can be
identified by its long length and the adjustable crossover cables can be identified by the ball
on the end of the cable. The routings for these cables are shown in the figures below.
NOTE: YOU MUST REMOVE ALL PULLEYS TO ROUTE THE CABLES.
USE A 9/16” COMBINATION WRENCH AND SOCKET TO DO THIS
(SEE FIGURE 16). YOU MAY WISH TO REMOVE THE SHOULDER
BOLTS (FIGURE 16 RIGHT SIDE) BY USING A 3/8” COMBINATION
WRENCH AND A 1/8” HEX KEY WRENCH. WHEN YOU HAVE
ROUTED THE CABLES, REPLACE ALL PULLEYS AND PLACE
END CAPS ON NUT AND BOLT ENDS. YOU MAY NEED TO PRY
THE PULLEY HOUSINGS OPEN TO REPLACE THE PULLEYS.
Figure 16. Removing the pulley bolts.