LifeSpan TR1200I manual Handlebar Assembly

TR800 / TR1200i

Folding Treadmill

Step 3: Handlebar Assembly

A.Rotate the handlebars down so they are positioned on top of the handlebar posts. Secure the right and left handlebars to the support post using the 2 M8 x70L screws (B) provided in the hardware bag sure there are no wires obstructing the bolt hole. Also, lightly pulling the handlebar one way or the other will help line up the bolt holes.

Note: Make sure that the wires on both sides are not pinched in-between the handlebars and the handlebar post.

B.Rotate the console bracket (8) up in the back until it reaches its normal operating position.

C.Place the left outside handlebar cover (9) next to the inside handlebar cover (pre-attached).

allowing the plastic ridge to sit in the groove of the blue rubber ring. Secure these three parts together using the self-tapping screws (C), which are pre-installed in the outer cover. Repeat this process on the other side with the right outside handlebar cover (10).

10 8

B

9

C

*Note: the TR800 inside handlebar cover is not pre-attached and comes in two pieces.

TR800

12

blue rubber ring

X

11