READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:46531
0198 | Page 3 of 3 |
WALL WIRING KIT INSTALLATION:
Follow instructions provided with WALL WIRING KIT 46700. Keep these instructions for reference purposes.
DIFFUSER DOOR INSTALLATION:
1.Loosen two ALLEN SCREWS in each of the two DRAW BOLTS (use allen wrench provided). (Fig. 3)
2.Slide both DRAW BOLTS towards the center of DIFFUSER DOOR; hook the NOTCHES in each end of DIFFUSER DOOR around each MOUNTING BOSS on ends of FIXTURE HOUSING. Slide DRAW BOLTS to ends of DIFFUSER DOOR making certain DRAW BOLTS fully engage over each MOUNTING BOSS. Secure DRAW BOLTS in position by tightening all four ALLEN SCREWS.
3.Swing DIFFUSER DOOR closed against FIXTURE HOUSING allowing two SPRING CLIPS to engage in SLOTS in FIXTURE HOUSING. Gently push DIFFUSER DOOR at each end until SPRING CLIPS fully snap into FIXTURE HOUSING.
Note: To open DIFFUSER DOOR for relamping; place finger into FINGER NOTCHES in each end of DIFFUSER DOOR and gently pull DIFFUSER DOOR away from front edge of FIXTURE HOUSING. (Fig. 3 )
CAUTION: Maximum wattage as marked on fixture must not be exceeded.
LAMP PINS
SLOT
FLUORESCENT
LAMP
SOCKET
Fig. 4
FLUORESCENT FIXTURES
HALOGEN
LAMP
LAMP PINS
LAMPING FIXTURE:
FLUORESCENT FIXTURES:
•Position pins in each end of lamp straight into SLOT in each SOCKET and twist lamp counterclockwise until lamp snaps into position (twist lamp approximately 90°). (Fig. 4)
CAUTION:
•DISCONNECT POWER TO FIXTURE BEFORE RELAMPING.
•DO NOT USE 12V LAMPS WITH THIS FIXTURE.
•DO NOT TOUCH LAMP WITH BARE HANDS.
Oils from hands could reduce LAMP life. Use tissue paper or cloth when inserting LAMP into SOCKET.
•DO NOT OPERATE FIXTURE WITH DIFFUSER DOOR OPEN.
RECTANGULAR
OPENING
Fig. 5
INCANDESCENT FIXTURES
PIN PROTECTOR
INCANDESCENT (HALOGEN) FIXTURES:
•Insert LAMP BASE into RECTANGULAR OPENING in PIN- PROTECTOR aligning PINS of LAMP with HOLES in SOCKET. Gently push LAMP into SOCKET until LAMP is fully seated into SOCKET.
LIGHTOLIER a GENLYTE company.
631 Airport Road, Fall River, MA 02720
