MAINTENANCE |
To service the pre-cleaner:
Remove the cover. Carefully remove the foam pre- cleaner from the filter element.
1.Wash in liquid detergent and water.
2.Squeeze dry in a clean cloth.
3.Saturate in clean engine oil.
4.Squeeze in a clean, absorbent cloth to remove all excess oil.
Carefully place the
CLEAN ENGINE: Remove dirt and debris with a cloth or a brush. Do not clean with a forceful spray of water. Water might contaminate the fuel system. Use low pressure air to blow out the machine periodically. In particularly dirty locations this may be required once a week.
SPARK PLUG SERVICE
To service spark plug, remove the 9 screws securing the side panel. Remove side panel and place provid- ed fiber spacer between the muffler and bottom of control panel. See Figure D.2.
FIGURE D.2
SLIP RINGS
CAUTION
A slight amount of darkening and wear of the slip rings and brushes is normal. Brushes should be inspected when a general overhaul is necessary. If brushes are to be replace, clean slip rings with a fine emery paper.
Do not attempt to polish slip rings while engine is running.
HARDWARE
Both English and Metric fasteners are used in this welder.
ENGINE MAINTENANCE PARTS
SUBARU ROBIN EX30
Air Filter Element | |
Spark Plug | Champion RL 86C |
(Resistor Type) | (Gap .025” [.65mm]) |
|
|
OPERATIONAL CLEARANCE
CAUTION
Approximately
ENGINE ADJUSTMENTS
WARNING
OVERSPEED IS HAZARDOUS - The maximum allowable high idle speed for this machine is 3750 RPM, no load. Do NOT tamper with the governor components or setting or make any other adjustments to increase the maximum speed. Severe personal injury and damage to the machine can result if operated at speeds above maximum.
Adjustments to the engine are to be made only by a Lincoln Service Center or an authorize Field Service Shop.
OUTBACK™ 145
¤
