Lincoln Electric 455 M manual Single Head Feeder, Single Head Boom Feeder, Configuring the System

A-6 INSTALLATION A-6

CONFIGURING THE SYSTEM

For codes below 11100, consult the semi-automatic Power Feed instruction manual for configuration infor- mation about DIP switch settings.

For codes above 11100 the power source will “Auto Map” the system eliminating most of the need to set DIP switches to configure the system.

If a system can not be “Auto Mapped” then the status light on the power source will blink green fast and the welder output will be disabled. If a system is not “Auto-mappable”, then consult the instruction manual for the accessory being used for configuration infor- mation about DIP switch settings, or consult your local Lincoln sales representative.

SINGLE HEAD FEEDER DUAL HEAD FEEDER

UP TO 4 FEEDERS

ALLOWED

POWER WAVE	POWER WAVE
455M(CE)	455M(CE)	FEED HEAD

SINGLE HEAD BOOM FEEDER

UP TO 4 FEED HEADS

ALLOWED

POWER WAVE

455M(CE)

FH 1

Typical Robotic/ Hard Automation

(using Wire Drive Module and PF-10R)

	POWER WAVE 455M(CE)
ROBOT
PLC CONTROLLER		WIRE
ANALOG INTERFACE		DRIVE
		MODULE

PF-10R

etc.

POWER WAVE 455M (CE)